In order to make the anti-radiation effect of the glass fiber grid great, pay attention to the following points during construction:
(1) The glass fiber grid adhesive is easily soluble in water. Do not apply when it is rainy or wet.
(2) Strictly control the entrance and exit of vehicles carrying mixtures, and prohibit the vehicle from turning, braking, and dumping scraps on the grille layer to prevent damage to the fiberglass grille.
(3) When the grid is laid, the road temperature should be between 5 ° C and 60 ° C.
(4) The glass fiber grid is made of glass fiber, which is easy to cause irritation to human skin. Construction workers must wear protective gloves.
(5) When the rubber roller is used to inject water to increase its weight, its water injection volume should not be too full to prevent it from overflowing onto the glass fiber grid and causing its back and abdomen to lose viscosity.
(6) During the laying of the glass fiber grid, if you find that the original pavement has a small pothole that has not been filled first, you can cut the part corresponding to the pothole on the paved grid to mix it with asphalt When the material is filled, the pit can be completely filled.